24 Jun 2016

New PCI Fault Insertion Switch Range for Differential Serial Interfaces (models 50-200/201)

Pickering Interfaces, a leading supplier of modular signal switching for electronic test and simulation, is expanding its range of PCI Fault Insertion switching with the introduction of two new modules (models 50-200 and 50-201) designed for use with differential serial interfaces.

PCI Fault Insertion Switch Cards for Differential Serial InterfacesThe new modules include the Differential PCI Fault Insertion Switch (model 50-200) which is designed for lower data rate serial interfaces such as CAN and FlexRay, and the High Bandwidth Differential PCI Fault Insertion Switch (model 50-201)  which is designed for higher data rate serial interfaces such as AFDX and 1000BaseT Ethernet. Each module allows the introduction of fault connections that include data paths open, data paths shorted together, and data paths shorted to externally applied faults such as power supplies and ground. The software driver defaults to a protective mode where conflicting faults are prevented to avoid accidentally shorting unintended paths, such as power to ground. A separate mode allows complete freedom in setting fault patterns. 

These PCI fault insertion modules will find application in testing the response of safety-critical communication systems used in automotive and aerospace environments. Each module is available with a choice of channel counts, allowing users to choose the most appropriate solution for the intended application. 

Pickering Interfaces continues to promote its test solutions in multiple platforms by offering fault insertion in different form factors (PXI and PCI) with the same options. This offering allows the user to choose the most appropriate platform for their test system. These two new PCI Fault Insertion Cards have the same functionality as their recently announced 40-200 and 40-201 PXI Fault Insertion Modules.

Both modules are supported by Pickering’s new eBIRST switching system test tool. These tools simplify switching system fault-finding by quickly testing the system and identifying the faulty relays. Once identified, the tools then display a graphical representation of the switching system’s PCB assembly, highlighting the relays that need to be replaced. 

Connections are available on an easy to use 78-way D connector and are supported by Pickering’s range of cable and connector options. In addition, Pickering Interfaces can design and supply interface adaptors to application specific connectors.

Back to Press Releases