Switch Sequence Manager
Available in all our LXI platforms*, this functionality allows users to set predefined switch/simulation operations on the 1000+ Pickering PXI switch and instrument cards.
A typical sequence in its simplest form can be defined in the following figure:
By grouping operations together, the number of control transactions needed to achieve a composite change in the target switch state is significantly reduced. This approach consolidates multiple operations within a single sub-unit into one streamlined action, effectively minimizing system switch settling time. For instance, if a user intends to operate X1-Y1, X4-Y1, and X2-Y2 in sequence, the system requires only a single operation and delay to execute the process.
Since the switch state sequences are stored directly within the LXI controller, the load on the host CPU and Ethernet traffic is significantly minimized. This optimization effectively reduces overall system latency, ensuring smoother and more efficient performance.
- System wide sequencing lets you address multiple switch and simulation cards in one sequence.
- User can upload up to 5000 pre-defined sequences.
- Hardware and software based triggers provided
- It negates Ethernet latencies when controlled using hardware triggers, resulting in more deterministic results.
- Easy-to-use User Interfaces for defining and controlling test sequences
Download switch sequence manageR AND THE GETTING STARTED GUIDE HERE
How to Identify if your LXI chassis has hardware triggering
Our LXI Sequence Manager provides both software sequencing and optional hardware sequencing. To determine if your chassis has hardware sequencing, look at the rear panel for a 25 pin D connector marked “IO/Trigger" (see examples below). If there is no such connector, you only have software triggering. Please refer to your LXI chassis manual for wiring information.
* Software Sequencing is available on all LXI systems. For hardware sequencing, please make sure the module supports triggering capability.