Mass Interconnect
Pickering recommends using a Mass Interconnect solution when an Interchangeable Test Adapter (ITA) is required for use with a PXI-based test system. Our comprehensive range of PXI modules is fully supported by Virginia Panel Corporation (VPC), MAC Panel and ODU Mass Interconnect solutions.
MacPanel Interconnect Solutions
What is Mass Interconnect for an Automated Test System?
Mass Interconnect is a mechanical interface that simplifies the connection between the power supplies, instruments and switching to the Device Under Test (DUT) in a test environment. In the illustration here, a test receiver is connected to the front of the modular instrumentation, in this case, a PXI chassis. This receiver is connected to the switching and instrumentation. An Interface Test Adapter (ITA) has a series of mating connectors that plug onto the Mass Interconnect. These connectors are wired either to a series of connectors that mate to the DUT or to a connector where a DUT PCB is inserted for testing. An enclosure is installed to protect the wiring and connectors.
Making Your Choices
If you have concluded that you need Mass Interconnect, you need to select a vendor. As listed above, there are three major players in the market – MAC Panel, ODU and VPC—as well as several smaller players. Pickering is not making any recommendations; your choice should be based on the available product, the level of support needed, and your test budget. All of these companies can support you with configuration, technical consultation, and customization as required. For ITA selection, your Mass Interconnection provider can help.
Connector types have well-defined specifications that should be observed. Connectors are rated for maximum voltage, current, power, and frequency. A connector rated at 100 Volts and 10 Amps is not necessarily a 1,000-Watt connector—it may be up to 100 Volts or up to 10 Amps, but not both. Be sure you understand your needs before specifying connectors. Before you make the vendor selection, be certain that you have determined the test system hardware required for all DUTs to be tested (this helps determine how large the receiver needs to be), the specifications and accuracy to be tested, and the DUT dimensions. If the DUT is a PCB, then CAD files will be critical for PCB placement. With the above information, your vendor(s) can help select the receiver and ITA sizes and configure the appropriate pinouts, receiver connectors, and required wiring.
To learn more about interconnect methods in your automated test system, download our book SwitchMate - A Practical Guide to Switching for Automated Test Systems