PXI Automotive Switch Simulator Modules
PXI switch simulator modules reproduce the behavior of automotive switches under real-world fault conditions, including dirty contacts and current leakage caused by contamination. Engineers use them to verify that automotive I/O devices respond correctly when switch inputs degrade, without exposing the unit under test (UUT) to damage. Pickering's switch simulator modules suit 12V and 24V systems and are built specifically for switch simulation in transportation electronics module testing.
What Is a PXI Switch Simulator Module?
A PXI switch simulator module is a modular test instrument that emulates the electrical characteristics of a physical automotive switch, including its fault states. Rather than wiring a real switch, which behaves inconsistently as its contacts wear, you use the module to generate repeatable "dirty" or "leaky" contact conditions on demand.
At a basic level, each channel provides a switch contact to the device under test (DUT). The module can introduce controlled contact resistance or leakage current to mimic a contaminated or degraded switch, then return to a clean state, all under software control. Built-in protection circuits guard the module against wiring faults or DUT failures, so a bench fault can't damage the instrument.
Engineers use PXI switch simulator modules to test electronic control units (ECUs) or I/O devices that read switch inputs, to confirm the devices behave correctly when those inputs aren't ideal. This is common in automotive and transportation electronics validation, where a body control module or similar device must tolerate contaminated switch contacts in the field.
The Switch Simulator Range
Pickering offers seven switch simulator modules across two families, giving you a consistent choice of channel count and topology to match your test plan.
40–480 Single-Bank Modules
The 40–480 series provides a single switch simulation topology across 8, 16, or 32 channels. Each module simulates automotive switch operation, where dirty contacts or leakage current can occur due to contamination, enabling automotive I/O devices to be tested under adverse conditions. Choose this family when your application needs a straightforward, higher-density channel count within a single bank.
- 40–480–021: 8 channels, single bank
- 40–480–121: 16 channels, single bank
- 40–480–221: 32 channels, single bank
40–485 Single- and Dual-Bank Modules
The 40–485 series offers the same switch-simulation function with a choice of one or two independent banks, allowing you to drive separate switch topologies from a single slot. This suits test setups that need to isolate groups of channels or exercise two UUT sections in parallel..
- 40–485–021: 8 channels, single bank
- 40–485–121: 8 channels, dual bankk
- 40–485–221: 16 channels, single bank
- 40–485–321: 16 channels, dual bank
How to Choose the Right Module
- Need the highest channel density in one slot? The 40–480–221 gives you 32 channels in a single bank.
- Need two independent switch topologies? Choose a dual-bank 40–485 (the 40–485–121 or 40–485–321).
- Working with a smaller channel count? The 8-channel 40–480–021 or 40–485–021keeps cost and slot use low.
Connectivity, Compatibility, and Integration
Every PXI switch simulator module plugs into any PXI chassis or a Hybrid slot in a PXIe chassis, so these modules can drop into your existing PXI-based test system without a dedicated chassis. They can also be hosted in Pickering's LXI/USB modular chassisfor remote operation over Ethernet or USB.
To speed up system integration, Pickering supplies mating cables and connectors for these modules. For test software development, Pickering provides Windows and Linux drivers along with signal-routing and simulation tools, so you can develop and verify your test program alongside the hardware.