The 41-670-201 is ideal for the simulation of Resolvers. It has four banks, each capable of simulating the output of a single 5 or 6-wire resolver.
Each simulation bank has an independent excitation input, and the ability to use an internally generated excitation signal. The module can also take a single input and distribute to all banks, reducing the load on the source and easing cabling. Due to the use of transformers, each input and output is galvanically isolated.
The Resolver simulator modules are designed for a wide band of excitation frequencies, with 300Hz to 20kHz as standard, while also offering input voltages up to 38V and output voltages up to 32V. Each excitation input frequency and amplitude can also be independently read back.
The phase relationship between the input and output signals is automatically adjusted to lag one cycle, which means the phase delay can be negated. In applications where this is not acceptable, one of the outputs can be used to propagate the input signal resulting in an in-phase signal with the output, which can then be used for demodulation.
With the addition of built-in relays, the 41-670 can also provide short or open circuits for each channel’s inputs and outputs, reducing the need for external switching for fault insertion requirements. The programmable phase delay can also be used for simulating imperfect sensors and cabling, artificially offsetting a single or multiple outputs.
The output amplitude is programmed using several options; these include Vsum and Vdiff when operating in 5/6 wire, percentage
displacement and independent voltage outputs. Vsum can be set as an absolute value or relative to the input amplitude.
Phase relationship is controlled via a programmable propagation delay. Additionally, the module can be programmed
with an actuator response, meaning rather than going from one position to the next directly, it can change at a constant
rate defined by the user.
* NOTE: In the part number, AABBCC corresponds to numbers for specific voltage input and output ranges. For a cross reference for these numbers and to specify a configuration for your application, please refer to the following resources:
If no specifications are present, please see the product datasheet in this section.
Please note: In some cases, for products like our Scalable LXI Chassis, the specifications can be found on the datasheets for the associated plugin modules that are inserted into these chassis. To find these modules, go to the "Also in the Range" link above.
Need to narrow down your search by specifications, try our Product Selector
Includes full information and specifications
PDF, 868.47 KB
Includes manual, extended specifications, installation instructions and data
PDF, 4.03 MB
Related 50 Pin D-type Connector Accessories Datasheet
A complete list and documentation for mating connection accessories
PDF, 3.4 MB
|Software Drivers and Downloads for Switching & Simulation Products|
Search our knowledgebase for information on software drivers, product comparisons and technical support for our entire product range.
Because we offer such a large range of products, this tool will help you narrow down our offering to get you the correct switch and simulation solution you need.
We supply and support our products across the globe, with seven offices in the Americas, Europe and Asia as well as additional representation.